![]() ![]() we put a pressure camera (made from silicon) inside "bottom" half.ĥ. each layer (from matrix surface to center) is a bit longer at the edge of the matrix half.Ĥ. after that we lay layers of carbon (+epoxy of course) - layer after layer. we attach inlet to this "base" half - so technically our matrix now consist of two halves.ģ. we take left half (for expample) and we consider it bottom half - we put it on the tableĢ. There are 3 parts - two halves (left and right) and inlet (which forms barrel and action channel)ġ. ![]() Now the pics.range report with TBAC 30BA on an 18" 308 coming up. #M39 stock crack top fullWhile I have not shot this yet, no reason this should not shoot to the action and shooters full potential.rigid, bedded right, and dimensionally stable.can't ask for more. Where the CF cloth meets is a work of art Plenty of room around the recoil lug to bed in your action/lug-clearance for/aft so this probably a must do A few (cosmetic only) voids on the show line between the bolt handle cutout and ejection port relief-not noticeable with the action in Bedding is done very well my action fit like a glove DBM works fine with my AICS and Alpha mags You can see the rough pencil marks showing where the relief needs to be cut in for the safety pivot The DBM setup is nice, well inleted, but just a little proud. The stock is very nice 100% top notch craftsmanship VTB certainly seems GTG to do business with! So, I will at least upload a few pics, show what has to be done, and give a few general observations. Busy, life, and a need to cut a little clearance for part of the safety selector. So I have had VTB's stock for over three weeks and not been able to get it to the range yet. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |